资料说明案例成果.pptxVIP

E5063A Revision A.02.00 OverviewSHP September 5, 2014September 2014Component Test DivisionKobe, JapanTarget Market and ApplicationsThe E5063A firmware has been enhanced to address the needs of key customers in the wireless RF component and PCB manufacturing test markets.Filter TestPCB Manufacturing TestMulti-DUT TestE5063A A.02.00 OverviewNew FeaturesRF Segment32 Channel / 16 Trace / 1601 point modeU1816A/C SP6T USB switch supportPCB SegmentProbe contact check mode for Flexible PCBTest range edit operator permissionAutoSave imagesKeysight rebrandingSplash screenAgilent Common Component Libraries (ACCL)E5063A A.02.00 Overview32 Channel / 16 Trace / 1601 point modeImproved efficiency for filter measurements.System Misc Setup Channel/Trace Setup 12 Ch / 4 Tr 10001 Points 32 Ch / 16 Tr 1601 Points *NEW*E5063A A.02.00 OverviewU1816A/C USB Coaxial Switch, Dual SP6T SupportLower cost solution for multi-DUT (antenna) measurementsUse case example:U1816A: DC to 8 GHzU1816C: DC to 26.5 GHzDUTDUTFixtureFixtureUSB footswitch for triggerOperator #1Operator #2E5063A A.02.00 OverviewProbe contact check mode for Flexible PCBEnsuring adequate probe contact is often difficult for flexible PCBs. A probe contact check (continuous trigger) mode is implemented to improve test efficiency.① Click [Run/Stop] to enter continuous trigger mode and check probe contact. Once contact is confirmed, click [Run/Stop] or [Measure] for single trigger.② A Contact Check ON/OFF switch is available for each test item.When Contact Check is ON, continuous mode is activated when selecting a test item in Execute Test Mode.Edit Test Mode②①Execute Test Mode①E5063A A.02.00 OverviewTest range edit operator permissionThere are cases when the operator on the production line needs to modify the test limit range during test. A test range edit permission flag was added to improve test efficiency.Execute Test ModeEdit Test ModeNote:Changes to the limit range are only valid during the selected test. Once another test